HMC Dual Head Log Shaver
Log Box
- 36” wide x 8’8” long x 30” deep
- ½” plate walls
- (2) support rings
- 10” diameter Carriage wheels with Timken tapered roller bearings
- (2) removable box extensions approx. 32” long for access to Planer Heads
Shaver Frame
- 4” x 6” x 3/8” wall tubing
- 1” thick bed plate 26’ long
- 4” x 6” x ½” angle iron cross bars under bed plate
- Hex style Track rails of #1045 steel with ½” base plate mounted to 3” x 5” x 3/8” wall tubing x 26’ OAL
- Bed plate height 48” from floor (leg base)
Planer Head Box
- (2) 6” diameter x 36” wide Shelix Spiral Planer Heads
- ¾” side plates
- ¾” bearing housing plates
- 2-1/2” shafts
- 2-1/2” high speed bearings
- Removable support plate between heads
- Adjustable bearing plate assemblies for depth of cut
- Head assembly on a slide out frame for changing knives/inserts
Traverse System for Log Box
- (2) cable drums on a common shaft
- (2) cable idlers
- (2) sets of ½” diameter drive cables with tighteners and cable mounts to each side of box
- 10HP TEFC motor with starter (mounted in main panel)
- Gearbox
- Chain Drive
- Speed adjust via HMI @ drive
- Potentiometer mounted in operator’s console
- Photocell and limit switch control of box travel
- Operators controls with “jog” override ability
Electrical System
- NEMA 12 motor control center enclosure
- (2) 75HP 1800RPM TEFC motors
- (2) 75HP Y-Delta starters
- (1) 10HP starter - traverse
- (1) 1HP starters – head pull out
- Fuse blocks for all motors
- Pre-wired control panel
- Pre-wired starters